VaraaAi
Academy

LashesStep-by-step practice·Lesson 26/68·5:58

Lash preparation: step by step

Everything before the first lash, step by step: welcome and consultation form, the eyes checked in good light, the test for first-time clients and its date recorded, bed, light and hygiene, contact lenses out and oil-free make-up removal, lash cleansing, rinsing and drying, pads covering every lower lash without touching the waterline, tape when needed, primer as the glue maker says, brushing, and the tray ready.

Speed

The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.

Safety first

How to do the test, waiting times, primer, room humidity and temperature: always as the glue maker says. A test does not guarantee that the client will not react later. Pads and tape never touch the eye itself. Rules on beauty services and products differ by country. This is a training aid, not a licence.

These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.

Key points to remember

  1. 1

    Welcome the client, wash your hands and consult while their eyes are open, on paper or a tablet: allergies, earlier reactions to glue or tint, eye conditions, eye surgery, contact lenses, current medicines, pregnancy, the look they want. The client reads it back and agrees.

  2. 2

    Tell the client beforehand: the appointment takes a while with the eyes closed throughout; if it stings, feels scratchy or they need a break, raise a hand, don't open the eyes.

  3. 3

    Check the eyes in good light: redness, watering, a stye, swollen or crusted lid margins mean stop. Look at the natural lashes too: dense or sparse, strong or weak, any broken lashes or patchy loss.

  4. 4

    First-time clients: test as the glue maker describes, often 24 to 48 hours before (a few lashes at the outer corner with the same glue you will use, or a little glue near the lash line). Ask the client to watch for a reaction and report back. Record the date, the glue and the result; if the client was tested earlier, check the record and ask again.

  5. 5

    Wipe the bed with a disinfectant wipe, fresh linen and headrest cover, neck support, even light that does not glare in the client's face. Wash your hands, then put on fresh gloves.

  6. 6

    The client takes out contact lenses. Remove eye make-up, mascara and creams with an oil-free cleanser: leftover oil weakens the bond.

  7. 7

    Cleanse the lashes with lash shampoo and a soft brush from root to tip, rinse with clean water with a tissue at the outer corner, and dry completely with a small fan held away from the face.

  8. 8

    Pads cover every lower lash, the top edge just under the lower lash line but never touching the waterline. Ask the client to look up slightly while you place them, then close; ask if anything feels scratchy and adjust at once. Check the outer corner: no lower lash pokes out.

  9. 9

    Medical paper tape when needed: to hold down stray lower lashes (only on the pad and cheek), or to lift the lid skin gently on hooded eyes. Never on the eye itself; ask the client if it feels tight.

  10. 10

    Brush the lashes, apply primer if the glue maker recommends it (single-use micro-brush, on the body and tips, away from the roots and lid skin), brush again. Tray ready: strips in map order, a fresh glue drop, disinfected tweezers, single-use items, glue bottle closed. Then continue as in the classic practice lesson.

Tips

  • The most common mistake: a pad placed too low or crooked so lower lashes poke out at the outer corner — they get glued to the upper lashes and pull when the client opens their eyes.
  • Save the test date, glue and result in the client's internal notes in VaraaAi (visible to the salon only, recorded with the client's consent).

Quick quiz

3 questions, 20 points for each right answer.

Question 1/3

Where should the top edge of the under-eye pad sit?