NailsStep-by-step practice·Lesson 12/58·4:37
Builder gel on natural nails: step-by-step practice
A builder gel (BIAB) overlay on the natural nail, no extension: consultation and checks, dry prep, a thin base layer, placing and floating the bead, turning the hand to form the apex, curing, finish filing, colour and top coat, oil and booking the infill.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
Cure times, lamp mode and how the base layer is handled (cured or not) always follow the brand's instructions. Gel must never touch the skin. If the customer feels burning heat, take the hand out for a few seconds, then finish the cure. Rules on nail products differ by country.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Consultation and checks: wash and disinfect hands, look at nails and skin (lifting, discolouration, swollen red skin, pus, open wounds: don't work, suggest a doctor), ask about earlier reactions to gel, natural or colour, and mention the 3–4-week infill up front.
- 2
Dry prep as in the gel polish lesson: no soaking, push back and remove the thin dead tissue on the plate, shape, buff off the shine without thinning the nail, brush off dust, wipe with a lint-free pad. Don't touch the nail plate afterwards.
- 3
A very thin base (slip) layer: work a little gel into the nail plate, wipe off the excess, cap the free edge and keep a tiny gap from the skin. Cure it, or build on it while wet, exactly as the product says.
- 4
Place one round bead of gel in the centre of the nail, not at the cuticle. Start with too little rather than too much.
- 5
With the tip of the brush, float the gel towards the cuticle with almost no pressure and stop a hair's width from the skin; then guide it to the side walls and the free edge and cap the tip. Thin at the cuticle and the sides, fuller in the middle.
- 6
Form the apex: turn the customer's finger nail-down and hold still for a few seconds so the gel gathers in the middle. Turn it back and check from the side (highest point over the stress area, slightly behind it) and end-on (an even C-curve). Correct while wet, but don't let the gel run into the edges.
- 7
Cure with the whole nail inside the lamp for the time the brand gives; use low-heat mode or a short flash cure if the brand recommends it. If needed, add a second thin layer the same way. Remove the sticky layer if the product leaves one.
- 8
Finish filing with dust extraction on: a 180 file flat on the surface to smooth it, never into the natural nail at the cuticle and never through the apex; refine the side walls and free edge, buff, brush off the dust (don't blow) and wipe.
- 9
Colour, if wanted, in thin coats as in the gel polish lesson, then a top coat that caps the free edge, fully cured. Finish with oil on the skin around the nail.
- 10
Aftercare: if it lifts, don't peel or pick — come back; gloves for washing up and cleaning; don't use nails as tools. Book the infill in about 3–4 weeks before the customer leaves. Clear up: single-use items into a lidded bin, metal tools cleaned and sterilised, gel bottles closed and kept out of sunlight.
Tips
- Bead tip: adding is easy, taking away is hard. Use little gel and two thin layers if needed — easier to shape and less heat in the lamp.
- In VaraaAi, create separate “Builder gel” and “Builder gel infill” services with your real durations, then book the customer's infill right at the desk.
Quick quiz
3 questions, 20 points for each right answer.
Where do you place the first bead of builder gel?