NailsStep-by-step practice·Lesson 16/58·4:42
Acrylic extensions: step-by-step practice
A sculpted acrylic extension on a form: consultation, dry prep, primer, fitting the form, picking up a bead, the three-bead method, setting and removing the form, checking from three sides, filing, finishing, aftercare and brush care.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
Switch on the local exhaust before opening the liquid; keep away from flames. Primer and acrylic must never touch the skin. Ratio, drying and setting times always follow the brand's instructions. Rules differ by country and city.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Wash and disinfect hands and check nails and skin: lifting, discolouration, swollen red skin, pus or open wounds — don't work, advise a doctor. Ask about past reactions, length and shape, and mention infills every 2–3 weeks. Switch on the table extraction.
- 2
Dry prep as in the gel polish lesson: push back, remove cuticle tissue from the plate, shorten the tip, take off the shine, dust and cleanse. Don't touch the nail plate afterwards.
- 3
Dehydrator and primer exactly as the brand says: one very thin layer, on the nail plate only, away from the skin and side walls; let it dry for the brand's time.
- 4
The form sits snugly under the free edge with no gap, in line with the finger; from the side it continues the line of the nail, neither dipping nor tilting up. With a tip: fit it to the nail's width, shorten it and blend the join thin.
- 5
Pour a little liquid into a dappen dish with a lid. Dip the brush, wipe it on the rim, touch the tip to the powder and hold it there a moment until a round bead forms. A good bead is moist, glossy and round — not dripping, not crumbly.
- 6
Bead one: on the form, just in front of the natural free edge — it sets the length, tip shape and straight side walls. Bead two: the stress area — it builds the apex and blends into the tip. Bead three: small, near the cuticle, pressed very thin with a hair-thin gap, never touching the skin.
- 7
Press and stroke with the belly of the brush held almost flat; wipe the brush and re-wet it between beads. If product touches the skin, lift it off at once while still soft.
- 8
Let it set (a few minutes, depending on the brand): a light tap with the brush handle gives a dry click. Never remove the form while soft; take it off gently, downwards. Check from the side (thin – highest at the stress area – thin), from the end (even C-curve) and from above (straight side walls).
- 9
File with the extraction running and a mask on, with a light hand: tip to shape, side walls straight, surface smooth with the apex kept; thin at the cuticle, blended into the natural nail but never filed into it. Buff, brush the dust off (don't blow) and cleanse.
- 10
Top coat or colour as the customer wishes, then oil. Advise: no prying, gloves for housework, oil daily, come back if it lifts, infill in 2–3 weeks. Clean the brush in the brand's own liquid (never acetone) and store it flat or as the brand says; close the dish and bottle, and dispose of leftover liquid per the safety data sheet.
Tips
- While you are learning, small beads are easier to control than big ones.
- A gap under the free edge lets acrylic run underneath: fix the form before the first bead.
Quick quiz
3 questions, 20 points for each right answer.
In the three-bead method, where does the second bead go?