NailsStep-by-step practice·Lesson 20/68·4:31
Shaping nails: step by step
Agree the shape and length with the client, make all ten nails the same length, find the centre line and the two stress points, then the filing path for each shape: square, squoval, round, oval, almond, coffin and stiletto; check symmetry from above and from the end, smooth the edge, remove the dust and finish with oil.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
This is a training aid, not a licence. Shared tools must be cleaned and disinfected after every client; single-use files and buffers are new for each client. Don't work on nails showing signs of disease or with red, swollen skin around them. Rules differ by country.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Wash and sanitise hands, look closely at the nails and skin. Ask the client about shape and length, show pictures of the shapes and say honestly which suits her nails.
- 2
Set the length first, then the shape: shorten long nails a little at a time with clippers, leaving a bit to file; all ten nails the same length. If one nail is broken short, match the others to it or extend that nail.
- 3
Look at the nail from above and from the end: find the centre line and the two stress points. The side walls run straight from the stress points; the tip sits on the centre line.
- 4
File lightly, slightly angled under the free edge; file natural nails in one direction with a fine file. Keep the client's finger straight and the same file angle on both sides.
- 5
Square: file straight across, straight parallel side walls, a light pass over both corners to soften them. Squoval: as square, then round both corners equally with a few short arcs.
- 6
Round: short nails, file from each side along the fingertip's curve up to the centre. Oval: longer, both sides curve evenly to a rounded tip on the centre line — don't go too deep or it becomes almond.
- 7
Almond: keep the side walls straight from the stress points, file at an angle from each side towards the centre into a soft rounded point; check after one side before filing the other.
- 8
Coffin: taper like almond but stop earlier, then file straight across for a small flat tip in the centre. Stiletto: steeper taper to a sharp centred point — only on enhancements or very strong natural nails.
- 9
Check every nail from above and from the end, put both hands side by side to compare all ten, and look from the client's side; correct any difference at once with a few light strokes.
- 10
Finish: smooth under the free edge with a fine buffer, brush off the dust with a soft brush (extract enhancement dust, don't blow it), apply oil and massage it in gently.
Tips
- Do the same step on all five fingers before the next (left sides of all five, then right sides, then the tips): your hand keeps one file angle and the nails come out more even.
- In VaraaAi, note the shape and length in the client's notes right after the appointment so you don't have to ask again next time.
Quick quiz
3 questions, 20 points for each right answer.
What should you do before you start shaping?