HairStep-by-step practice·Lesson 54/68·4:35
Curtain fringe and face framing: step-by-step practice
A centre-parted curtain fringe on long hair, step by step: preparation, a dry consultation and finding cowlicks, the triangle section, a long first cut, the two diagonal halves, face-framing pieces, drying the fringe, refining dry with point cutting, checking symmetry, three common mistakes, and the finish.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
The customer keeps their eyes closed while you cut around the face; scissor tips point sideways, down or outwards, never towards the eyes. Neck strips are single-use; combs, scissors and clips are cleaned and disinfected after every customer (lesson “Tools after every customer”). Fringe techniques differ between schools and countries. This lesson is a training aid, not a licence.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Preparation: wash your hands, tools cleaned and disinfected, a single-use neck strip first, then the cape.
- 2
Consult on dry hair: lay hair on the forehead to show where the fringe will end (for a curtain fringe the shortest point usually touches or sits below the brows), ask about styling, glasses, wearing it up; lift the hair to find cowlicks and tell the customer.
- 3
Section a triangle on damp hair: two diagonal partings from the front corners above the outer brows to the apex, both sides equal; comb the rest back and clip it. Take less hair first — you can add more.
- 4
A long first cut: eyes closed, comb the fringe straight down without tension, fingers barely holding at the tip of the nose, cut below the fingers with the tips pointing sideways. Damp hair shrinks, so don't cut to the agreed length yet.
- 5
Part the fringe in the centre; comb each half down beside the face, fingers on a diagonal from the middle of the forehead to the cheekbone, cut along the outside of the fingers with the blades parallel to them, well away from the eyes. The other half at the same angle, compared with the first.
- 6
Face framing: a thin section in front of the ear, fingers on a diagonal continuing the fringe line to the chin or collarbone, cut below the fingers, tips down, away from the face; the long hair behind keeps its thickness.
- 7
Dry the fringe first: nozzle pointing down, brush it left and right a few times so the roots lie flat, then a small round brush turns the two halves out to the sides.
- 8
Refine on dry hair: eyes closed, shorten a few millimetres at a time and let go to look again; point-cut to soften the ends with your fingers between the scissors and the face, never too deep.
- 9
Check symmetry: customer sitting up, head straight, eyes ahead; compare both sides at the same point by the cheekbones, step back to see the whole face, ask the customer.
- 10
Finish: brush off clippings before the customer opens their eyes, let them try styling it once, note the fringe length and cowlick side in the record, book a trim in a few weeks; clean and disinfect the tools.
Tips
- Three common mistakes: pulling the fringe tight before cutting, cutting while the customer tilts or lowers their head, and taking hair too far out towards the temples.
Quick quiz
3 questions, 20 points for each right answer.
Where should the first cut of the fringe be?