VaraaAi
Academy

HairStep-by-step practice·Lesson 52/68·4:36

Layered cuts: step-by-step practice

Long layers with face framing step by step, keeping almost all the length: preparation, consultation and touch points, shampoo, parting and sectioning, the perimeter at 0°, long layers on top at 180° to a stationary guide, the sides over-directed back to keep the front long, face framing over-directed forward, cross-checking and balance, blow-drying, body position and keeping the elevation, finishing, notes and clean-up.

Speed

The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.

Safety first

Elevation names and teaching methods differ between schools and countries; this is a training aid, not a licence. Cut only to the agreed length; start long and go shorter later. Around the face, ask the customer to close her eyes and point the scissor tips away from her face. Scissors, combs and clips are cleaned and disinfected after every customer as the product instructs; neck strips are single-use (lesson “Tools after every customer”). Rules differ by country.

These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.

Key points to remember

  1. 1

    Wash your hands; tools cleaned and disinfected; neck strip first, then the cape.

  2. 2

    Consult on dry hair: how much off the ends, where the face framing starts (touch point), whether she blow-dries or ties her hair up; what she disliked last time. Fine hair: fewer layers.

  3. 3

    Shampoo, blot, detangle; part the hair where she will wear it; section; keep it evenly damp.

  4. 4

    The perimeter: head straight, combed straight down, 0°, cut straight across below the fingers, centre first then the sides. A U or V outline must be agreed first. The layers never cut into the perimeter.

  5. 5

    Long layers on top: section the top, comb it straight up to 180°, gather it to one point above the head (stationary guide) and cut straight across. Take a little first, let it down and look; not too short at a whorl.

  6. 6

    The sides: a vertical section behind the ear is the stationary guide, connected to the top layers; sections in front of the ear are over-directed back to it and only the excess is cut — the front keeps its length. The other side the same.

  7. 7

    Face framing: a triangular front section combed forward, eyes closed; cut along a diagonal starting at the agreed point, scissor tips away from the face. Sections behind are brought forward to the first one → longer towards the back.

  8. 8

    Cross-check with horizontal sections; in the mirror compare the two shortest face pieces and trim the longer one bit by bit.

  9. 9

    Blow-dry with a round brush, lifting the roots on top and turning the face pieces away from the face; once dry, check balance, volume and that the ends are still full.

  10. 10

    Throughout: stand right in front of the section, keep the elevation when your arm tires, always start long. At the end: hand mirror, show how to style, notes; many customers come back after about 2–3 months (a habit, not a rule).

Tips

  • A tired arm drops without you noticing — the elevation changes and so do the layers. Pause, reposition, then go on.
  • In VaraaAi, note the length and where the face framing starts in the customer notes, and suggest the next appointment at checkout.

Quick quiz

3 questions, 20 points for each right answer.

Question 1/3

Which step usually comes before the interior layers?