HairStep-by-step practice·Lesson 50/68·4:35
One-length cuts and bobs: step-by-step practice
Cutting long hair into a chin-length one-length bob step by step: preparation and neck strip, consultation and touch point, shampoo and keeping the hair damp, removing the extra length, sectioning, the nape guideline at zero elevation, the back layers, the sides and the ears, checking both sides and the back, blow-drying and the dry check, three common mistakes, finishing, notes and clean-up.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
Names and teaching methods differ between schools and countries; this is a training aid, not a licence. Cut only to the length agreed with the customer. Your fingers always stay between the blades and the customer's skin. Scissors, combs and clips are cleaned and disinfected after every customer as the product instructs; neck strips are single-use (lesson “Tools after every customer”). Rules differ by country.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Wash your hands; scissors, combs and clips cleaned and disinfected. A single-use neck strip first, then the cape.
- 2
Consult on dry hair: reference photo, how she wears it; agree the length with a touch point at the chin; find nape whorls, look at the neck and shoulders; leave curly hair longer.
- 3
Shampoo, blot, detangle from the ends; keep the hair evenly damp. You may first remove the extra length, leaving a few centimetres below the bob line. If she wants to keep the hair: ponytail it and cut it dry, before the shampoo.
- 4
Centre parting, sections, clipped flat. Release one very thin horizontal section at the nape; clip the rest up.
- 5
The guideline: chin slightly down. Comb straight down, 0°, very light tension; cut straight across just below the fingers, centre first, then the sides; check it is parallel to the floor.
- 6
The back layers: each thin horizontal section combed down over the guide and cut exactly to it, up to the crown. At the occipital bone, comb straight down without lifting.
- 7
The sides: head upright. Take a little of the cut back hair as the guide and connect forwards to the chin. At the ear, no tension; work layer by layer, then the other side the same.
- 8
Check: head straight, compare the ends at both sides of the chin and trim the longer side bit by bit; look from behind and from the side; blend the little corner behind the ear.
- 9
Blow-dry in the direction of fall, turning the ends slightly under; check again once dry and snip stray hairs; point cut only if she wants a softer edge.
- 10
Finish: hand mirror, adjust right away if she wants, show how to blow-dry at home, record the length in the customer file. Many customers come back for a trim after about 6–8 weeks (a habit, not a rule). Clean and disinfect the tools.
Tips
- Three common mistakes: lifting the hair at the occipital without noticing, pulling hair tight over the ear, and a tilted head or crossed legs.
- In VaraaAi, suggest booking the next trim right at checkout and note the length in the customer notes.
Quick quiz
3 questions, 20 points for each right answer.
The back is done. What do you do before the sides?