HairTheory & experience·Lesson 55/68·5:50
Blow-drying: understand it for smooth, shiny hair without damage
Why blow-drying shapes hair (wet hair is easy to reshape, dry and cool hair holds it), the cuticle and a nozzle pointing down the hair shaft, towel-drying, detangling and heat protection as the product says, rough-drying before the brush, sections, round and paddle brushes, the concentrator and tension, the cool shot, root volume, smoothing and turning the ends under, curly hair with a diffuser, heat and distance to protect hair and scalp, the stylist's posture, and cleaning brushes and the dryer.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
Use heat-protection products as their instructions say, and the dryer's heat settings as the manufacturer says. Never press the nozzle against the scalp or hold it in one place too long, and ask the customer whether it is too hot. Brushes are cleaned and disinfected after every customer (lesson “Tools after every customer”). Methods differ between schools and countries. This lesson is a training aid, not a licence.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Wet hair is easy to reshape; once completely dry and cool it holds the new shape. Water or humid air slowly undoes it.
- 2
The cuticle lies like roof tiles from root to tip: airflow down the hair makes it shine, airflow upwards makes it frizz. The nozzle always points down the hair shaft.
- 3
Towel-dry by pressing, detangle from the ends, then apply a heat protector as instructed. It reduces damage but never replaces good technique.
- 4
Rough-dry by hand to roughly seventy or eighty percent before using a brush — faster and less heat. Section the hair and start at the nape; each section no wider than the brush and not too thick.
- 5
Paddle brush: straight, smooth, fast. Round brush: volume, bent ends, curls — a big one gives a soft bend, a small one more curl. Metal or ceramic barrels get hot: keep them off the scalp.
- 6
Keep the concentrator nozzle on, parallel to the brush and a few centimetres away, following the brush from root to tip. Enough tension for smoothness — pull the hair, not the customer's head.
- 7
After each section, keep it on the brush and use the cool shot for a few seconds before releasing it: the shape lasts longer.
- 8
Volume: lift the section high and dry the roots first. Smooth: direct it down close to the head and dry downwards. Ends under: the brush goes under the section and turns in at the ends. Curls to keep: a diffuser on low, no brushing.
- 9
Fine, fragile, coloured or bleached hair: moderate heat; thick, coarse hair can take more but keep the dryer moving. Never press it to the scalp; ears and nape burn easily; ask whether it is too hot.
- 10
Posture: the chair at a height that keeps your elbows below your shoulders, back and wrist straight, switch hands when you can, a light dryer. After every customer remove hair from the brushes, wash and disinfect them; clean the dryer's filter regularly.
Tips
- If the customer's head follows the brush, you are pulling too hard: ease off and take smaller sections.
- In VaraaAi, set separate durations for “Cut + blow-dry” and “Blow-dry only”, and note the brush, products and the look the customer likes (volume or sleek) in the customer notes.
Quick quiz
3 questions, 20 points for each right answer.
Why should the nozzle point down the hair shaft?