VaraaAi
Academy

HairTheory & experience·Lesson 49/68·4:38

One-length cuts and bobs: understand them for a straight, balanced line

What one-length means; the one-length, A-line and graduated bob; agreeing the length with a touch point; reading the neck, nape whorls and shoulders; natural fall, zero elevation, tension, wet versus dry and curl shrinkage; sections and the stationary guideline at the nape; head position for the nape and the sides; the ears; cross-checking and balance; the dry check and point cutting; safety and hygiene.

Speed

The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.

Safety first

Names and teaching methods differ between schools and countries; this is a training aid, not a licence. Always agree the length with the customer before cutting. Your fingers always stay between the blades and the customer's skin. Scissors, combs and clips are cleaned and disinfected after every customer as the product instructs; neck strips are single-use (lesson “Tools after every customer”). Rules differ by country.

These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.

Key points to remember

  1. 1

    One-length: every hair, falling naturally, stops at the same line. Around the chin it is usually called a bob. From behind it is straight across; from the side it is parallel to the floor.

  2. 2

    One-length bob: a level line. A-line bob: shorter at the back, longer towards the face. Graduated (stacked) bob: the nape is cut with a little elevation for volume at the back. Names vary from place to place.

  3. 3

    Agree the length with a touch point (at the chin, touching the shoulder…), not with words like “a little” or “short”. Ask whether the customer ties her hair up or tucks it behind her ears.

  4. 4

    Read the neck and nape: a nape whorl makes a very short bob line kick up. Hair that stops right on the shoulders hits them and flicks out — choose above the shoulders or clearly below.

  5. 5

    Cut in natural fall, at zero elevation, with light, even tension. Wet hair pulled tight shrinks up when dry, shorter and uneven.

  6. 6

    Straight hair shrinks a little when dry; wavy and curly hair much more. For curls: leave it longer than intended, or cut dry with a technique you have learned.

  7. 7

    Start with a very thin horizontal section at the nape: the guideline. Each following layer is combed straight down and cut exactly to it (a stationary guide). Thin sections let you see the guide.

  8. 8

    For the nape: the customer's chin slightly down, kept the same until the back is done. Before the sides: head upright, sitting straight, legs not crossed.

  9. 9

    The ear pushes hair out: pull it tight over the ear and cut, and once released it leaves a gap above the ear. At the ear, let the hair fall naturally and hold it very lightly.

  10. 10

    Check throughout: compare both front ends at the same height with the head straight; look from behind and from the side. Check again once dry; point cut only if the customer wants a softer edge.

Tips

  • A slightly tilted head makes the sides look uneven even when they are right — always straighten the head before comparing.
  • In VaraaAi, note the length and touch point in the customer notes, so whoever cuts next time gets it right.

Quick quiz

3 questions, 20 points for each right answer.

Question 1/3

At what elevation is a one-length bob cut?