HairTheory & experience·Lesson 51/68·5:54
Layered cuts: understand them for lightness and movement without losing length
What layers do and what they take away; reading the hair before layering (thick, fine, curly, whorls); elevation at 0°, 45°, 90° and 180° (common names); travelling and stationary guides; over-direction to keep the front long or to frame the face; the perimeter first; face-framing layers and how the customer wears her hair at home; tension, evenly damp hair and body position; cross-checking and balance; four common mistakes.
The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.
Safety first
0°, 45°, 90° and 180° elevation are common names; schools measure and name them a little differently, and teaching differs between countries. This is a training aid, not a licence. Around the face, the scissor tips point away from the customer's face. Scissors, combs and clips are cleaned and disinfected after every customer as the product instructs (lesson “Tools after every customer”). Rules differ by country.
These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.
Key points to remember
- 1
Layers: the upper hair is shorter than the hair below and overlaps it. The hair gets lighter, with volume and movement — but layers take weight away from the ends.
- 2
Read the hair first: thick, heavy hair gets lighter with layers; fine, thin hair needs few, long layers; curls shrink a lot when dry; don't cut layers too short at a whorl.
- 3
0°: hair falls straight down, a one-length line. 45°: the hair stacks low down and keeps weight (graduation).
- 4
90°: at right angles to the head where you cut, uniform layers following the head — suits short and medium hair; on long hair it removes length. 180°: straight up to the top, shortest on top and longer below — long layers that keep the length.
- 5
Travelling guide: each new section includes a little of the one just cut → uniform layers. Stationary guide: every section is brought to one place → the further from it, the longer the hair.
- 6
Over-direction: pull the front hair back to keep length at the front; pull it forward to frame the face, with the hair behind getting longer. Always notice which way you are pulling.
- 7
Usually the perimeter comes first, at 0°, to the agreed length; the layers must blend softly into it, never cut into it.
- 8
Face framing: agree where it starts (cheekbone, chin, collarbone) and start longer than intended. Think of how she wears it: tied up, air-dried or blow-dried.
- 9
Light, even tension; evenly damp hair; stand right in front of the section you cut — standing off to one side changes the elevation without you noticing.
- 10
Cross-check (vertical sections are checked with horizontal ones); compare the two shortest face pieces; after blow-drying, look again for even volume and holes.
Tips
- Four common mistakes: top layers so short they stand up, thin see-through ends, uneven face pieces, and lost front length from over-directing the wrong way.
- In VaraaAi, note the length and where the face framing starts in the customer notes, so it can be repeated next time.
Quick quiz
3 questions, 20 points for each right answer.
A long-haired customer wants layers but to keep her length. Which elevation suits the top best?