VaraaAi
Academy

HairStep-by-step practice·Lesson 56/68·4:39

Blow-drying and styling: step-by-step practice

A smooth, shiny blow-dry on long layered hair with soft root lift and softly bent ends: preparing brushes and dryer, towel-drying and detangling, heat protection, rough-drying by hand, sections from the nape, a round brush with the nozzle pointing down, the cool shot, the sides and face framing, volume at the crown, the fringe, common mistakes, and the finish.

Speed

The narration is in Vietnamese (subtitles: CC button on the player). The steps below are in English.

Safety first

Use heat protectors and serums as the product says, and the dryer as the manufacturer says; check the cord and the filter before use. Never press the nozzle against the scalp, shield the ear when drying right next to it, and ask whether it is too hot. Brushes are cleaned and disinfected after every customer (lesson “Tools after every customer”). This lesson is a training aid, not a licence.

These videos are study aids. They don't replace supervised hands-on training and they are not a professional licence. Always follow the product manufacturer's instructions and the rules where you work.

Key points to remember

  1. 1

    Preparation: round brush, paddle brush and clips cleaned; the dryer with the nozzle firmly on, a clean filter and an undamaged cord; the chair at a height that keeps your elbows below your shoulders.

  2. 2

    Towel-dry by pressing from roots to ends, no rubbing; detangle with a wide-tooth comb from the ends up, holding the hair above.

  3. 3

    Heat protection: spray evenly over the lengths and ends as the product says, don't miss the ends, keep it away from the face; comb it through.

  4. 4

    Rough-dry by hand, nozzle down, a hand's span from the hair, roots first, always moving, to roughly seventy or eighty percent dry; check at the nape and behind the ears.

  5. 5

    Sections: clip the upper hair up on top, leaving a thin layer at the nape about as wide as the brush.

  6. 6

    Lower layer: round brush close to the roots, the nozzle parallel to the brush, pointing down, a few centimetres away; draw the brush slowly to the ends with even tension, the dryer following; turn in at the ends. For poker-straight hair use a paddle brush.

  7. 7

    Cool shot: keep the finished section on the brush, use the cool shot for a few seconds, release only once it is cool; let down the next layer and work upwards.

  8. 8

    Sides and face framing: dry them back, away from the face, the brush inside the face-framing pieces turning outwards; gentle near the ears, shield the ear, ask whether it is too hot; compare both sides in the mirror.

  9. 9

    Crown: lift the section high, the brush at the roots, dry the roots first with the nozzle still pointing down, draw out to the ends, cool shot, then release; dry the parting left and right. A fringe is dried first of all.

  10. 10

    Finish: check the roots and nape are completely dry, a little serum on the ends as instructed, show the customer how to do it at home, let them look and ask about changes, note the brush, products and preferred look; tidy up and unplug the dryer.

Tips

  • Common mistakes: the nozzle pointing upwards, holding the dryer in one place too long, sections too thick. If hair tangles in the round brush, switch off and unwind it slowly the other way — never yank.

Quick quiz

3 questions, 20 points for each right answer.

Question 1/3

When do you start using the round brush?